Product Code: APA-2018-65658
Product Code: APA-2018-65658
The Manley Silver Tube Microphone is large condenser microphone inspired by the legendary Sony C-37A and built in collaboration with Josephson.
The Manley Silver Tube Microphone uses a capsule designed by David Josephson who has provided a stunning recreation of the C-3 capsule originally used on the C-37 microphone in the ‘50s. This capsule is single-ended and boasts an adjustable acoustic chamber on the back allowing the user to change between omni and cardioid polar patterns. This capsule delivers a rich a creamy tone associated with the original Sony microphone.
Inside the microphone, lies a unique circuit design which combines a FET and vacuum tube cathode used to amplify the signal before hitting Manley’s IRON transformer. This design provides a bit less output than other microphones and can, therefore, accommodate loud sources very well.
The power supply has been specifically designed for audio fidelity with all regulated lines, super low impedance rails and no 50Hz/60Hz ripple component present in the chassis. It works at any voltages between 90V and 250V so all you need to do is plug it in.
This microphone offers a rich and warm sound that will complement female vocals and saxophones particularly well without any boxiness or sibilance. It will also impart its sonic glory on drum overheard with a warm mid frequency response shaving off the harshness produced by cymbals when used with other microphones. Its dark tone means that it can often be used instead of a ribbon microphone.
Manley Silver Tube Microphone Main Features:
Condenser Transducer based on vintage Sony C-37A Hand Made in USA by Josephson Audio
Single-Sided Large Diaphragm Capsule Edge Tensioned
5 Micron Evaporated Gold Diaphragm 1" diameter
Dual Pattern Cardioid or Omni Directional adjustable via vent on the backplate
5670 Internal Vacuum Tube Head Amplifier
Constant Current Source for Tube Minimizes Noise and Tube Selection
Hand Wound Nickel Core Manley Iron Output Transformer
Output Impedance: 30 Ohms
High Pass Filter Switch -3dB @ 55Hz 6dB/8va
FREQUENCY RESPONSE: 10Hz-30kHz, AMP to 60kHz
MAXIMUM INPUT SPL: 150 dB SPL at Capsule
AMPLIFIER TYPE: 2 Triode Gain Block Lo Z Output
OUTPUT POLARITY: Balanced XLR, Pin 2 Hot, Pin 3 Low
AMPLIFIER DISTORTION: Less Than 0.05 % THD+N BW 22-22 kHz (1kOhm Load, 1kHz -40dBV Output)
AMPLIFIER NOISE: Typically -108 dBV “A Weighted”
BODY: Etched Silver Anodized Aluminum
Weight: 1.5 lbs (mic)
Weight: 2 lbs (PSU)
Size: 2" x 9.7" x 4.5" (mic including suspension)
Size: 5" x 8.2" x 3.4" (PSU)
Custom Designed Outboard Switched Mode PSU 90V ~ 250VAC Universal Voltage Operation 50Hz-60Hz
Power Consumption: 15 Watts
PSU External Mains Fuse: 5mm X 20mm, 2A @ 250V, CERAMIC, Slo-Blo
|Free Installments||36 Free Interest Installments|