.Lipinski power amplifiers are dual topology, which means there are two separate power amplifiers Inside. Our state-of-the-art power amplification uses dual topology: we employed dual mono design not only for the stereo amp, but also for our monoblocks. This is to control one parameter which has substantial influance on the perception of quality: the damping factor. This one controls the speed and accuracy of lowest frequencies, resulting in very tight and controlled bass. This configuration also significantly lowers distortion.

The L-401 monoblock, due to the same dual topology design as the subwoofer amp, can be used in biamplificaion mode.  Bi-amp mode increases microdynamics.  The L-401 can also be switched for bridged mode, allowing for 600 Watts of unfettered power per channel.

Since we believe that the best speaker cable is short cable, the L-401 is designed to be built into our speaker stand, making up the L-3601 Powered Stand.The stand fits directly underneath the L-707A Monitors.

Be sure to check out our Reviews section for the latest review of our Monoblock, against Pass Labs and Bryston.

Specifications

• Output power: 1 channels: 200W @ 8ohms, 300W @ 4ohms,
• Gain: 30/35dB,
• Bandwidth: 1Hz–50kHz -3db,
• Integrated high pass filter optimized for L-505A/L-707,
• THD+noise: 0.01% THD @ 50W, <1% THD @ rated power,
• Signal to Noise ratio: 102db @ rated power,
• Input impedance: 10kohms,
• Inputs: 1x XLR, 1x RCA,
• Outputs: 1x XLR, 1x RCA,
• Multi color front glass light,
• Dimensions: 17.3"H x 3.1"W x 8.7"D (44cm x 8cm x 22cm),
• Weight: 33 lbs (15 kg).